Q: Can you use rivets to install AMS-1004 Anchor Trolley
A: The preferred install of the LeverLoc Anchor Trolley is to use the included stainless steel, blunt tip, thread forming screws or the backing plates featured in the LeverLoc Anchor Trolley HD. If you can't reach the backside of the install with your hands to attach the backing plates check out the YakAttack Rigging Bullet
Product: Anchor Trolley (AMS-1003 & 4) | Manufacturer Part Number: AMS-1003 / 4
Q: What is the deminsion between holes on the outside pulleys? Compatible with 2018 Hobie PA14 w/installed nuts?
A: From the center of one hole to the other the spacing is 1.18" on the YakAttack Stealth Pulleys. It does require different hardware than what is included in this kit, but the Stealth Pulleys will fit in the molded-in threaded inserts on the bow and stern of the Hobie Pro Angler 12 and 14. It might take a little work but the pulleys will fit.
Product: Anchor Trolley (AMS-1003 & 4) | Manufacturer Part Number: AMS-1003 / 4
Q: What anchor can I use with the anchor trolley?
A: We recommend a 3-4 lb anchor but no more that a 5lb anchor when using our Anchor Trolley
Product: Anchor Trolley (AMS-1003 & 4) | Manufacturer Part Number: AMS-1003 / 4
Q: How far in should I install the pulleys on my kayak?
A: We recommend installing the pulleys at least 5-6 inches towards the inside of your kayak
Product: Anchor Trolley (AMS-1003 & 4) | Manufacturer Part Number: AMS-1003 / 4
Q: My paracord for my Anchor Trolley is kind of sagging below the side of my kayak, what kind of solution can you recommend to help with this problem?
A: The paracord will stretch and shrink when it is wet, it may take a few times to get the tension right. When designing the Anchor Trolley, we wanted to design a ring where the trolley line is very easy to tighten. You could try to tighten the string by retying the overhand knot. Another quick solution would be to add an extra pad hook.
Product: Anchor Trolley (AMS-1003 & 4) | Manufacturer Part Number: AMS-1003 / 4
Q: Which rigging bullet do you use for the install of the Anchor Trolley?
A: The rigging bullet that you would use for the install of the Anchor Trolley is the RB1032.
Product: Anchor Trolley (AMS-1003 & 4) | Manufacturer Part Number: AMS-1003 / 4
Q: What is the difference between the HD Anchor Trolley and the standard?
A: The difference between the two is the extra pad hooks and the backing plates for a heavy duty installation. The HD is recommended when you are in salt water or heavier currented waters
Product: Anchor Trolley (AMS-1003 & 4) | Manufacturer Part Number: AMS-1003 / 4