Camera Mounts (CMS)
Q: Do any of the camera mounts float?
A: The only camera mounts that float are the PanFish Pro (CMS-1002) and Boomstick Pro (CMS-1003).
Product: Camera Mounts (CMS-1002) | Manufacturer Part Number: CMS-1002
Q: What is the difference between the Boomstick Pro and the Panfish Pro Stick?
A: The major differences between these two camera mounts is the height and the mount in the middle of the Panfish. The Boomstick is 51.5" tall and the Panfish Pro is 33" tall. Regarding the Panfish Pro, in the middle of the mount, you are able to rotate the top portion of the mount 360 degrees.
Product: Camera Mounts (CMS-1002) | Manufacturer Part Number: CMS-1002
Q: My PanFish Pro is no longer as tight as it was when I first purchased the mount. Is it expected that the friction point in the middle loosens over time?
A: Over time the halves will become looser and you can tighten it. The first step is to move the bottom foam, that is in the middle of the Camera mount,down. You should see a hole on one side of the camera mount. Once you see that hole, you will need to rotate the top part of the camera mount, until you see another hole align with the first original hole. The second step: by using a rivet gun place a 1/16” rivet in both holes (or really anything small enough and strong enough to fit into the small hole, our assembly team uses the rivet) and from there you will be able to tighten the camera mount. Once you have tighten the camera mount as much as you would like, you will need to remove the rivet. Then you are done and your camera mount is good to go.
Product: Camera Mounts (CMS-1002) | Manufacturer Part Number: CMS-1002